4th year membership
Use:metal Drilling
Material:High Carbon Steel
Description:
1.[APPLICABILITY] Remove the broken or damaged screws.
2.[EASY TO USE] Just 3 easy steps. Removes every stripped screw in 10 seconds or less!
3.[MATERIAL]: double head damaged screw remover is made of high speed steel 4341;
4.[DIFFERENT SIZE AND TYPE] This screw remover set itself comes with four different size bits. Two sides can be used. So it can be used on any screw types / size.
5.[What you get] 4 pieces screw remover.
Note: If you have any confusion, please feel free to cantact us, we will answer your question with profession attitude.
Package:
5 * screw extractor
1 * plastic case
Remover 1 # diameter 3 - 5mm
Remover 2 # diameter 4 - 8mm
Remover 3 # diameter 5 - 10mm
Remover 4 # diameter 6 - 12mm
Firstly, using drill head to penetrate drill, be careful not to use the impact hammer gear, with the normal screwdriver gear.
Secondly drilling time to the slowest speed, there is a fixed speed with fixed speed, no in the end speed file a certain to be able to evenly rotate.
After the volley speed is stable and then aligned with the top of the screw center for a long time. Don't worry, be patient.
Then when you obviously felt drilled into and drilled for a while, and then for another.
The head rotates, puts the rotating head into the hole just drilled, presses and turns on the electric screws .It can be removed normally.
The whole process reverse operation
Note: 1. The remover is designed for screws that slide or break the head, and the stuck or rusty screws need to be operated together with the flashlight drill. And the speed should be slow, do not be too high or suddenly speed up.
The whole process needs to reverse the operation, first take one head open, then take the other end out, the success rate of the removal is very high.
2. Hardness at 58 degrees -60 degrees, wood screw is no problem (not suitable for steel plate operation)
3. The remover is suitable for orthodontature screws, anti- screws are not applicable
Q: What are the skills for novices?
A: The bit speed can't be too fast, so low speed!Broken wire extractor is double-ended.
Step (1): Drill bit that head first drilling, speed needs to be based on different material settings.
The harder the material, the slower the speed of the drill
Step 2: When the extractor is taken out, the drill should be reversed, and the rotation speed should not be too fast. Otherwise, it is easy to slip the teeth. The extractor should be able to slowly remove the screws.
