QC Finishing Supervisor

行业	Manufacturing	职位	Manufacturing
招聘部门		招聘人数	若干
工作地区	Laguna	工作性质	Full Time
性别要求	Male	婚姻要求	No marital status restrictions
学历要求	College Diploma	工作经验	不限
年龄要求	18岁以上	待遇水平	面议
更新日期	2022-09-27	有效期至	Valid for a long time

Preferably with experienced in Manufacturing of Rubber parts as Quality Control, at least one (1) year.GENBA oriented.At least one year training "skill".Job Responsibilities:Will be in-charge at Finishing and In-process Sections.Conduct verification of quality of products and evaluates the results.Responsible in the identification of Abnormal Condition and change points and ensures implementation of the corresponding controls.Promote "Early Detection" of quality

Miyasaka Polymer (Phils.), Inc. is a Philippine Economic Zone Authority (PEZA) registered company, which was established on November 1994 and started its operation on October 1995. Initially, the factory building covers 2,650m2 from  the total land area of 10,507m2. The company is engaged in the manufacture of molded rubber parts including assembly with other parts such as plastic connector and metal. Our products are used not only in the automotive industry but also in Electric Appliances, Medical Instruments, Cameras & Microscope Parts, Compressor Seal Parts and Electronic Microswitch Pads. Majority of our products are exported to other countries such as Japan, Germany, USA, Singapore, Thailand, Hongkong, China, Vietnam, Indonesia and other ASEAN Countries.  Remaining parts are provided for the domestic market in the Philippines. On September 2005, another building with an area of 2,800m2 became operational, increasing the total factory area to 5,459m2.The company is the 5th factory among the six (6) factories of Miyasaka Rubber Group and the first to be located outside of Japan. On the year 1999, the company embarked in the improvement of the Quality Management System and successfully acquired ISO 9001:1994 QMS certification  on May 20, 2000. On May 2003, the same Quality Management System was successfully upgraded to ISO 9001:2000 QMS. On 2006, the QMS wa successfully upgraded to ISO/TS 16949:2002 to comply with the automotive customers.On 2008, Environmental Management System was established based on ISO 14001:2004 Standards and was certified.